MIL-STD-2219 Fusion Welding for Aerospace Applications S/S by AWS-D17.1The scope of this document is to provide minimum requirements for weld filler materials, workmanship, inspection and record requirements for fusion welding of alloys applicable to aircraft, missiles, other aerospace equipment, their parts and accessories.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43

MIL-STD-2219A

w/CHANGE 1

5.1.4.2 Bare welding wire and welding rod

Each spool or coil shall carry an identifying label and each piece of bare welding rod shall be marked.  Marking shall comply with the requirements of AMS2816, AWS A5.01 or other system acceptable to the cognizant engineering organization.

5.1.4.3 SAW flux

Each container shall be labeled by type and size.

5.1.5 Gases

Gases listed in the "Specification" column of TABLE I shall be used unless the alternate specification is specified by the cognizant engineering organization.

5.2 Manufacturing controls

5.2.1 Joint configuration

Joint design and dimensions shall be as specified on the drawing or in the welding procedure.  The resulting weld shall meet the applicable requirements of 5.4.3 and

5.4.3.5.

TABLE I.  Gases (minimum requirements).

13